5-28 BA 901/1101 en – Edition 2.1 * 91101b530.fm
Maintenance
Servicing and maintenance at regular intervals
Before performing machine travel
☞ Check every time before performing machine travel:
• Is the light system OK?
• Is the signaling and warning system OK?
Every week
☞ Check once a week:
• Electric fuses – see chapter Fuse box behind the seat on the left on page 6-4
• Cable and grounding connections
• Battery charge condition – see Battery on page 5-29
• Condition of battery terminals
Instructions concerning specific components
Cables, bulbs and fuses
Always observe the following instructions:
• Malfunctioning components of the electrical system must always be replaced by an
authorized technician. Bulbs and fuses may be changed by unqualified persons.
• When performing maintenance on the electrical system, pay particular attention to
ensuring good contact in leads and fuses.
• Blown fuses indicate overloading or short circuits. The electrical system must therefore
be checked before installing the new fuse.
• Only use fuses with the specified load capacity (amperage)– see chapter Fuse box
behind the seat on the left on page 6-4
Alternator
Always observe the following instructions:
• Only test run the engine with the battery connected.
• When connecting the battery, ensure that the poles (+/−) are not inverted.
• Always disconnect the battery before performing welding work or connecting a quick
battery charger.
• Have malfunctioning charge indicator lights immediately replaced – see chapter 26
Indicator light (yellow) – cold starter 3-8 on page 3-6
To Next Page
Loading...
Need help?
General
