3-48 BA 901/1101 en – Edition 2.1 * 91101b330.fm
Operation
Cabin entry and exit
When leaving the cabin –
Accident hazard!
☞ Bear in mind the following before leaving the cabin:
• Stop and secure the machine – see Parking the machine on page 3-32
• Lower the loader unit and the attachments
• Apply the parking brake
• Stop the engine and remove the starting key
• Move control levers 5 and 20 in all directions several times to release
the pressure in the hydraulic system
☞ Raise safety bars 7/14
➥ The gas strut keeps the safety bar in the top position
The machine is exposed to heavy dirt during work operation. Dirt piles up on
the footholds, therefore be careful when entering and leaving the cabin –
Injury hazard!
☞ Always remove dirt from the footholds
☞ Be careful when entering and leaving the cabin
Do not use safety bar 7/14 as a support to ease your entrance to the cabin:
☞ Use the entrance handholds on the cabin
Entering the cabin:
☞ Hold onto handholds A
☞ Step onto footholds B on the bucket,
☞ then step onto footholds C with both feet,
☞ enter into the machine and sit down on the seat
☞ Fasten your seat belt
☞ Lower safety bars 7/14 after you have entered
➥ Gas struts keep safety bars 7/14 in the lower position
As a rule, you can access and exit the cabin only at the front. The rear window can
be used as an exit in an emergency – see Emergency exit on page 3-44.
Fig. 93: Entry/exit
A
B
C
7
A
14
20
5
To Next Page
Loading...
Need help?
General
