BA 901/1101 en – Edition 2.1 * 91101b320.fm 3-13
Operation
3.7 Performing machine travel
Preheating start switch (overview)
The engine can also be started without lowering the safety bar!
If the engine stalls or if it is stopped, only start the engine again after 6 seconds.
Accelerator actuation
Throttle lever 18 controls the engine speed as follows:
• Continuously (throttle lever )
Engine speed control with pedal throttle 1:
• Pressing the accelerator pedal briefly increases the engine speed set with the manual
throttle.
Output cannot be increased with the accelerator pedal if maximum engine speed
has been set with the manual throttle.
1
0
2
3
Fig. 43: Preheating start switch
Position
Function Power consumer
0
Insert or remove the starting key None
1
ON/travel position
All functions are operational
➥ Indicator lights illuminate
2
Preheats the engine
(10 – 15 seconds)
3
Starts the engine
➥ Starter is actuated
➥ Indicator lights must go out
Fig. 44:
Fig. 45: Accelerator pedal
1
Fig. 44: Throttle
18
To Next Page
Loading...
