5-22 BA 901/1101 en – Edition 2.1 * 91101b530.fm
Maintenance
5.11 Tires (model 901)
Use of wrong tires or wheels –
Accident hazard!
☞ Use only wheels and tires authorized for your machine
☞ Check the wheel nuts for tightness after every wheel or tire change!
The wheels are heavy and can damage the threads on the wheel studs if they
are handled incorrectly!
☞ Use suitable assembly tools, such as covering sleeves for the studs, a jack,
etc.!
In case of increased tire wear, we recommend replacing the tires of the front and
rear wheels in due time.
Raising and jacking up the machine
Jacking up the machine incorrectly or insufficiently –
Accident hazard!
☞ Jack up the machine with adequately sized jacks!
Removing
Proceed as follows:
☞ Park the machine on level and firm ground and prevent it from rolling away
☞ Slightly loosen the wheel nuts of the wheel you want to remove
☞ Place a jack under the axle body, ensuring that it is standing firmly
☞ Raise the side of the axle from which you want to remove the wheel
☞ Check the compact loader is standing firmly
☞ Completely remove the wheel nuts
☞ Remove the wheel
Installing
Proceed as follows:
☞ Place the wheel onto the wheel bolts
☞ Tighten all wheel nuts part-way
☞ Lower the raised axle
☞ Tighten the wheel nuts to the specified torque of 175 Nm
Subsequent to changing wheels check the wheel nuts for tightness after
10 operating hours – tighten if necessary!
To Next Page
Loading...
Need help?
General
