5-34 BA 901/1101 en – Edition 2.1 * 91101b530.fm
Maintenance
5.18 Maintenance if the machine is out of service for a longer period of time
If the machine is out of operation, run it once a month without load. Remove
the grease from the piston rods first!
Preparatory work before taking out of service
☞ Carefully clean and dry the entire machine.
☞ Apply grease to all lubrication points
☞ Change the engine oil
☞ Apply grease to the piston rods of the hydraulic cylinders
☞ Check all oil levels and add oil if necessary
☞ Fill up the fuel tank completely to avoid corrosion on the walls
☞ Check the antifreeze in the coolant, change as required
☞ Check the tire pressure for the prescribed value and protect the tires from direct sunlight
☞ Check the track tension for the prescribed value and protect the tracks from direct
sunlight
☞ Remove the grounding strap from the battery, or remove the battery and store it in a
safe place
☞ Close the exhaust pipe and the air intake opening of the air filter system
Store the machine indoors if possible. If storing the machine outdoors cannot be
avoided, place it on wooden boards and cover it with a tarp.
Putting into operation again
☞ Remove the grease from the piston rods
☞ Install or connect the battery
☞ Remove the seals from the exhaust pipe and the air filter intake.
☞ Check the condition of the air filter cartridges and replace them if necessary
☞ Change the oil if the machine has been out of service for over 6 months
☞ Also replace the return, suction and breather filters if the machine has been out of
service for over 6 months
☞ Lubricate the machine according to the lubrication plan
☞ Start the engine and let it run without load
To Next Page
Loading...
Need help?
General
