Sawmill Alignment
Complete Alignment Procedure
Sawmill Alignment 60HDdoc102619 7-39
7
Blade Guide Level
Perform the following adjustments to make sure the blade guide assembly is parallel to the blade.
1. Loosen the alignment bar mounting bolt. Use the provided bottom disk adjustment tool to adjust the
alignment bar up so the bar is close to, but not touching the bottom of the blade. Retighten the
alignment bar mounting bolt
2. Check that the gap from the alignment bar to the blade is the same along entire length of the bar.
Shine a flashlight behind the blade guide assembly to help you see the gap between the bar and the
blade. To adjust, loosen the rear clamp bolts, but leave snug. Determine which outer bolt to use to tilt
the blade guide assembly as desired. Loosen the jam nut and turn the bolt until the alignment bar is
parallel to the blade. Retighten the jam nut and clamp bolts. Repeat for the second blade guide
assembly.
See Figure 7-40.
FIG. 7-40
Loosen rear
clamp bolts
Check gap between
blade and alignment
bar (see Detail)
Use bottom disk adjust-
ment tool to raise align-
ment bar close
to blade
Outer tilt
adjustment bolts
Blade has
the same distance
from bar along
entire length of bar
DETAIL
To Next Page
Loading...
Need help?
General
