Maintenance
Miscellaneous
Maintenance 60HDdoc102619 5-7
5
vomiting - contact a physician. KEEP OUT OF THE REACH OF
CHILDREN.
5.7 Miscellaneous
1. Oil all chains with Dexron III ATF every fifty hours of operation.
CAUTION! Do not use chain lube. It causes sawdust buildup in chain
links.
2. Apply a thin film of a NLGI No. 2 grade lithium grease to the blade guide arm every fifty hours of
operation to help prevent it from rusting.
3. Adjust the blade guide arm drive chain as necessary. To adjust the chain, loosen the blade guide arm
motor mounting plate bolts and slide the motor to take slack out of the chain.
4. Grease the clamp mechanism, loading arms and side supports with a NLGI No. 2 grade lithium
grease every fifty hours of operation.
5. Check the mill alignment every setup (See SECTION 7
).
6. Make sure all safety warning decals are readable. Remove sawdust and dirt. Replace any damaged
or unreadable decals immediately. Order decals from your Customer Service Representative.
7. Lubricate the actuator arm, bracket and braking lever axis every 150 hours of operation with a NLGI
No. 2 grade lithium grease. Apply grease to the grease fitting shown below.
To Next Page
Loading...
Need help?
General
