Troubleshooting Guide
Circuit Breaker Operation
6
6-19 60HDdoc102619 Troubleshooting Guide
6.11 Circuit Breaker Operation
Sawmill controls are equipped with manual reset circuit breakers to protect the electrical circuits.
See Figure 6-5. The power feed and up/down breakers are externally mounted at the front of the
control box. The blade guide, accessory, ignition, start, and board return breakers are located inside
the control box. Remove the circuit breaker panel from the control box to access the internal break-
ers.
NOTE: If the breaker is still hot, you may not be able to reset it immedi-
ately. Allow the breaker to cool for a few minutes before attempting to
reset.
To Next Page
Loading...
