Troubleshooting Guide
Hydraulic Problems
Troubleshooting Guide 60HDdoc102619 6-10
6
6.5 Hydraulic Problems
PROBLEM CAUSE SOLUTION
You Can Actuate Any
Hydraulic Handle, But
Get No Response From
The Pump.
Carriage not positioned
properly to provide power to
the pump
Make sure carriage contact bracket is adjusted far
enough forward for battery positive contact to touch
6ft. strip on main tube. Check contact and strip for
tarnish or loose wires. Clean as necessary.
Poor ground connection Check ground connection between pump and saw
frame and between battery negative contact and
lower rail. Check contact and rail for tarnish or loose
wires. Clean as neccesary.
Blown fuse Replace.
Low or dead battery Test battery amperage capability (such as low
battery charge, low alternator ouput, defective
voltage regulator, bad battery cell, battery age
deterioration, etc.). Replace or recharge as
necessary.
Defective pump motor Remove motor from pump and inspect. Repair or
replace as necessary.
Poor cable connection Check cable connection and make sure that battery
terminals are in good condition (not corroded).
Defective solenoid (may be
indicated by solenoid clicking)
See Monarch manual for
troubleshooting solenoid
After checking all other possibilities for low voltage
to solenoid, check solenoid. Tapping on solenoid
may fix temporarily. Replace solenoid if necessary.
NOTE: The solenoid is not a standard automotive
type. Order from Wood-Mizer only.
To Next Page
Loading...
Need help?
General
