Troubleshooting Guide
Hydraulic Problems
6
6-11 60HDdoc102619 Troubleshooting Guide
PROBLEM CAUSE SOLUTION
You Can Get Response
From the Pump By
Actuating All But One or
Two Handles
Valve assembly switch
contacts are not properly
adjusted
Locate the valve switch at the bottom of the valve
assembly. Use a 3MM allen wrench to loosen the
set screw on each of the five switch contacts. Press
each contact to the valve block and tighten the
contact set screw to secure in place. CAUTION! Do
not overtighten!
NOTE: Do not adjust the valve switch or switch
spring; they have been preset at the factory.
To Next Page
Loading...
