Maintenance
Vertical Mast Rails
5
5-6 60HDdoc102619 Maintenance
5.5 Vertical Mast Rails
Clean and lubricate the vertical mast rails every 50 hours of operation. Clean with solvent and
remove any rust with a light-grade sand paper or emery cloth. Lubricate the mast with motor oil or
automatic transmission fluid (ATF).
CAUTION! Never use grease on the mast rails as it will collect
sawdust.
5.6 Drum Switches
Lubricate the up/down and power feed drum switch contacts inside the control panel every fifty hours
of operation. Use only contact grease supplied by Wood-Mizer. Remove the control panel cover.
Use a cotton swab to apply grease to the switch contact ends.
WARNING! Drum switch grease contains Petroleum Hydrocarbon
Lubricant. Eye and skin irritant. If introduced into eyes, flush with water
for at least 15 minutes. If film or irritation persists, seek medical
attention. Wash skin with soap and water. If ingested, do not induce
FIG. 5-3
Clean sawdust
from track roller
housings
Clean and
lubricate
track wiper
Adjust track
scrapers
600011
Track
Rail
Clean and
lubricate
track wiper
Clean sawdust
from track roller
housings
Track
Rail
Adjust track
scrapers
To Next Page
Loading...
Need help?
General
