Sawmill Setup
Sawmill Setup
Sawmill Setup 60HDdoc102619 3-1
3
SECTION 3 SAWMILL SETUP
3.1 Sawmill Setup
IMPORTANT! Before starting to use the sawmill you have to meet the
following conditions:
Set up the sawmill on firm, level ground and level the sawmill. Secure the sawmill to the
ground to prevent moving during operation. A concrete foundation or pads (rated to support
31 T/m
2
at each sawmill foot position) and 16mm anchored bolts are recommended.
Under roof, the sawmill should always be operated with the sawdust collection system.
The sawmill can be operated under roof only.
The sawmill can be operated in temperature range from -15
o
C to 40
o
C only.
Illuminance at operator's position must be 300lx.
The sawmill operator’s position is shown below.
Tie the belts in the places shown on the picture below. The sawmill can be lifted using a forklift,
a winch or a crane. The belts and the lifting equipment must be rated for at least 3000kg
(6600 lb).
WARNING! When lifting the sawmill, use extreme caution and keep all
persons at a safe distance. Failure to do so may result in serious injury
To Next Page
Loading...
Need help?
General
