Sawmill Operation
LT70 WIDE Lube System Operation
Sawmill Operation 60HDdoc102619 4-16
4
additive, so it works with hard water.
WARNING! Use ONLY water and Wood-Mizer Lube Additive with the
water lube accessory. Never use flammable fuels or liquids such as
diesel fuel. If these types of liquids are necessary to clean the blade,
remove it and clean with a rag. Failure to do so can damage the
equipment and may result in serious injury or death.
If you are sawing in freezing temperatures, remove the water lube bottle from the sawmill when done
sawing and store it in a warm place. Blow any remaining water from the water lube hose.
See the separate LubeMizer System manual for operation instructions.
4.11 LT70 WIDE Lube System Operation
See Figure 4-1. The Lube System keeps the blade and the wheels clean and cools them. When
shut-off valve (A) is open, the coolant (ACP-1 oil) flows from the tank (B) through hoses to surfaces
of the wheels. Oil dispensers (C) located on the saw head control the amount of oil flow.
Use just as much coolant as it is necessary to keep the blade clean. Usually, it is sufficient to set the
dispensers so that one drop flows every 3 seconds.
WARNING! Never use flammable fuels or liquids! If these types of
liquids are necessary to clean the blade, remove it and clean with a
rag. Failure to do so may result in serious injury or death.
Before removing the blade, start the motor with the START button. Let the blade spin with oil running
on it for about 15 seconds. This will clean the blade of sap buildup. Wipe the blade dry with a rag
FIG. 4-1
To Next Page
Loading...
Need help?
General
