Maintenance 60HDdoc102619 5-1
MAINTENANCE LOG
(Check Engine And Option Manuals For Additional Maintenance Procedures)
Check Blade Screw See Section 5.2 Daily - Every Blade Change
Check Blade Guide Performance See Section 5.2
Daily - Every Blade Change
DAILY MAINTENANCE PROCEDURES
Remove Excess Sawdust From Blade Wheel Hous-
ings And Sawdust Chute
See Section 5.3 Daily - Every Blade Change
Clean Sawdust From Hydraulic Loader Fuses, Bat-
tery Box Lid & Track Cover
See Section 5.3
Daily - Every 8 Hours
Clean And Lubricate Track See Section 5.4
Daily - Every 8 Hours
Remove Sawdust From Upper Track Roller Housings See Section 5.4
Bi-Weekly - Every 25 Hours
Clean And Lubricate Upper Track Wiper See Section 5.4
Bi-Weekly - Every 25 Hours
PROCEDURE
MANUAL
REFERENCE
TOTAL HOURS OF OPERATION
FILL IN THE DATE AND THE MACHINE HOURS AS YOU PERFORM EACH PROCEDURE.
A SHADED BOX INDICATES MAINTENANCE IS NOT NEEDED AT THIS TIME.
50 HRS 100 HRS 150 HRS 200 HRS 250 HRS 300 HRS 350 HRS 400 HRS 450 HRS 500 HRS
Lubricate drum switches See Section 5.5
Grease pivot points and bearings/Oil chains See Section 5.6
Lubricate blade tensioner screw See Section 5.6
Check brake strap tension See Section 5.8
Check belt tensions See Section 5.9
See Section 5.11
Check feed & up/down chain tensions See Section 5.11
See Section 5.12
Check up/down & power feed gear box fluid levels See Section 5.11
See Section 5.12
Inspect hydraulic lines & fittings See Section 5.10
Check hydraulic fluid level See Section 5.10
Replace hydraulic system filter See Section 5.10
Inspect hydraulic pump, power feed and up/down
motor brushes
See Section 5.10
See Section 5.11
See Section 5.12
To Next Page
Loading...
Need help?
General
