Input, Output and LED Settings
Checking the Assignments of a Digital Input
In order to check the targets that a Digital Input is assigned to please proceed as follows:
Call up menu [Device Parameter\Digital Inputs].
Navigate to the Digital Input that should be checked.
At the HMI:
A multiple assignment, that means if a Digital Input is used more than once (if it is assigned to multiple targets), this
will be indicated by an ”...” behind a Digital Input. Call up this Digital Input by Softkey »Arrow right« in order to see
the list of targets of this Digital Input.
110 MCDGV4 DOK-HB-MCDGV4-2E
To Next Page
