7 System Administration
116
System Administration
7
Procedure for Changing System Settings
To establish or change system settings that differ from the factory default settings,
it is necessary to be in System Administration mode.
This section describes the basic procedure for changing system settings. The following
are the required steps:
Step 1 Entering System Administration Mode .........................................................................116
Step 2 Entering the System Administrator Password ...............................................................116
Step 3 Selecting the Items from the [System Settings] Screen.................................................117
Step 4 Selecting the Features ....................................................................................................118
Step 5 Exiting System Administration Mode ...........................................................................118
Step 1 Entering System Administration Mode
1
Press the <Log In/Out> button.
Step 2 Entering the System Administrator Password
To enter System Administration mode, enter the system administrator password.
It is recommended that you change the system administrator password immediately
after the machine is installed.
For information about establishing or changing the password, refer to "System Administrator -
Password" (P.146).
1 Enter the system administrator password using
the numeric keypad, and select [Confirm].
Note • The default password value is "11111".
4
7
2
5
8
0
3
6
9
Transmitting
Machine Status
Log In/Out
Jobs in Memory
Original/
Copy
Scan
Menu
Power Saver
Clear All
Copy from
Stop
Start
Interrupt
Media Settings
Memory
.
C
1
<Log In/Out> button
Cancel
System Administrator
- Enter Password
Password
Confirm
xxxxxxxxxx
To Next Page
Loading...
Need help?
General
