DocuColor 5000 User Guide
7-2
7. Maintenance
Cleaning the UI screen
Clean the UI screen at the start of each day. Remove all dust and
fingerprints by wiping the screen with a clean, lint-free cloth.
CAUTION: To avoid damage, do not use any Xerox cleaner,
water, or commercial cleaner on the screen.
Cleaning the Second Transport and Fusing areas
Use the following procedure if your output prints have dirt or
contamination on them, or if you receive multiple paper jams in
Area 4.
NOTE: It is recommended that you perform this procedure one
time per day, preferably at the start of the day before the digital
press is switched on and the fuser is hot.
WARNING: If the digital press is switched on and the fuser is hot,
be sure to switch off the digital press power and allow 15 minutes
for the fuser to cool before performing this procedure.
1. Open the front doors.
2. Grasp handle 4 and move it in the direction of the arrow.
Front Doors
To Next Page
Loading...
