DocuColor 5000 User Guide
4-37
4. Accessories
NOTE: To undock the stacker/stapler from the digital press, reach
into the circular area near the bottom of the stacker/stapler for the
Undocking Lever. Refer to the picture below.
Pull the lever toward you and hold it in position while moving the
stacker/stapler a small distance (25.4mm, 1in.) away from the
press. Release the lever and continue to move the stacker/stapler
as far as required.
Loss of Power
If power is interrupted to the stacker/stapler:
• Ensure the power cord is plugged in to the proper wall
receptacle.
• Ensure that the digital press power is on.
• If the power has not been restored by the above procedure,
call Xerox Customer Support.
Also call your Xerox service representative if the loss of power to
the stacker/stapler seems to be frequent or excessive.
Location of Undocking Lever
To Next Page
Loading...
