Xerox Docucolor 5000 - Drilled Paper; 1-Sided Print Jobs

DocuColor 5000 User Guide
3-7
3. Paper information
Drilled paper
Three-hole drilled paper can be run from all the trays either LEF or
SEF with the holes facing any direction.
NOTE: If you are stapling 3-hole drilled paper with the optional
Common Stacker Stapler (CSS), refer to page 4-31 for paper
loading instructions based on the position of the staple.
Drilled paper should be run in the Simplex (1-sided) and Duplex
(2-sided) orientations shown below to avoid paper jams caused by
the holes not aligning correctly with the paper sensor in the press.
1-Sided Print Jobs
Load the drilled paper into any tray in the Long Edge Feed (LEF)
direction. Refer to the following illustration:
2-Sided Print Jobs
Load drilled paper into any tray in either the Long Edge Feed
(LEF) or Short Edge Feed (SEF) direction. Refer to the following
illustration:
NOTE: If you are stapling 3-hole drilled paper with the optional
Common Stacker Stapler (CSS), refer to page 4-31 for paper
loading instructions based on the position of the staple.
Rear of paper tray
Right
side
Front of paper tray
Paper
tray
guides
Rear of paper tray
LEF direction
Rear of paper tray
Paper
tray
guides
Paper
tray
guides
Right
side
Front of paper tray
Front of
paper tray
SEF direction