5. Locate the fuser identifier clip on the fuser assembly and, using a marker, write on
the identifier the fuser width being used.
6. Locate the two bypass fuser connectors in the kit. The black resistor jumper (left) is
used for the number 2 range value and the blue jumper (right) represents the number
3 range value. For the range numbers, refer to the bypass connector table in Fuser
Paper Width Information. .
7. Attach the appropriate jumper to the exposed white connector at the front of the
fuser assembly by pushing the two ends together. There is no release. To disconnect,
simply pull apart.
8. Position the fuser front cover on the assembly and screw tightly in place.
9. Close the left and center front doors of the press.
Note
If the paper in the print job does not match the width set for the fuser, an error
message displays and the job does not print. Cancel the job and submit the correct
paper width for that job, or change fusers so that the correct width-range fuser is
installed.
6-41Xerox
®
Versant
®
3100 Press
User Guide
Maintenance
To Next Page
Loading...
Need help?
General