Xerox Versant 3100 Press - Page 134

Suggested Solutions
2. Create and/or use an existing Alignment Profile.
Note
Before creating a new and/or using an existing manual alignment, read all the information
in the Stock Library Manager Help for “Alignment Profiles.”
• Use Center Line Stock for Alignment Profiles. If the problem occurs when using this
stock, call the Customer Support Center.
• For more information, refer to the Stock Library Manager > Help > Alignment Profiles.
• The following is a summary of the steps required for each procedure; for complete in-
structions, refer to the Stock Library Manager Help for “Alignment Profiles,” “Creating /
Editing an Alignment Profile.”.
• To create a New Alignment Profile, perform the following:
a. From Stock Library Manager (on the print server), select Profiles > Alignment.
b. From the Alignment tab, select the New button.
A “New Profile Properties” window displays.
c. Enter the Name you want to assign to the profile.
d. Perform the Auto Alignment procedure.
e. Run a set of test prints to evaluate the output, and evaluate the results.
f. If necessary, depending on the results, perform a Manual Adjustment.
g. When making manual adjustments to multiple items, use the following guidelines:
• Adjust the image in the following order: Registration, Perpendicularity, Skew, and
Magnification.
• Choose only one option at a time (such as Registration), then run a set of test
prints to evaluate the output. Determine if the printed output for the selected option
is acceptable and if it is acceptable, then select and adjust the next alignment op-
tion.
• After each option is selected, always run a set of test prints and evaluate the output.
Determine if the output for the selected feature is acceptable, and if it is, continue
to adjust another alignment option as required.
• To use an existing Alignment Profile, perform the following:
Note
The option may be found by selecting Stock Library Manager > Stock Properties >
Advanced Stock Setup > Alignment Profile.
a. From the Stock Properties of the desired stock, select Advanced Stock Setup > Align-
ment Profile.
b. Select either Use Default or Select from List.
If using Select from List, make a selection from the list of saved Alignment Profiles.
3. Change the Aligner Roll Pressure setting.
Tip
Changing the default setting of 0 (zero) is a temporary solution because environmental
conditions vary from day to day. Upon completion of the print job, the recommendation
is to return the option to its default setting.
• Use this feature to adjust the aligner roll pressure.
Xerox
®
Versant
®
3100 Press7-16
User Guide
Troubleshooting