Xerox Versant 3100 Press

To Next Page

To Previous Page

Suggested Solutions

Note

An automatic adjustment fixes most image quality issues. Always perform the Auto

procedure before performing the Manual adjustment.

- Auto: The adjustment is done automatically by the press. It eliminates the need

for you to interpret printed targets, and manually enter adjustment values. This

saves time and avoids errors.

- Manual: The user must manually perform the adjustment, including printing test

patterns, interpreting the printed targets on those patterns, and then manually

entering the adjustment values.

Tip

Use the Manual adjustment option only when the Auto adjustment does not

provide the desired output.

- For detailed information and instructions on using the Auto and Manual adjustment

options, refer to Stock Library Manager Help for “Advanced Stock Setup Feature,”

“Secondary Transfer Voltage Adjustment Overview.”.

2. If the issue is observed on the tail edge of the printed output and is not corrected by per-

forming a Secondary Transfer Voltage Adjustment, change the Transfer Output Adjust-

ment for Trail Edge setting.

• Use this feature to adjust the voltage ratio on the secondary bias transfer roll (2

BTR);

this is where the image is transferred from the belt to the paper.

• This feature is accessed from Stock Library Manager > Stock Properties > Advanced

Stock Setup > Transfer Output Adjustment for Trail Edge.

• Decrease the Transfer Output Adjustment for Trail Edge in increments of 10%. After

every incremental adjustment, run test prints and evaluate the output to determine if

additional adjustment is necessary.

3. Perform an Automatic Density Uniformity Adjustment.

Note

This is a press feature and is not a Stock Library Manager feature.

• Use this feature to correct image quality issues on the output when that image quality

is not consistent throughout the entire output. For example, the image quality is lighter

(faded) or heavier (thicker) on the left or right sides of the output (inboard / outboard).

• For information and instructions on how to use this feature, refer to Adjusting Automatic

Density Uniformity.

Problem

Image Registration, Perpendicularity, Skew, and Magnification

Xerox Versant 3100 Press - Page 133