Xerox Versant 3100 Press

To Next Page

To Previous Page

Suggested Solutions

• From the Paper Curl Correction screen, under the type of job that is experiencing the

problem (1 Sided – Face Up, 1 Sided Face Down, or 2 Sided), select the Edit Settings

button.

• When changing the Paper Curl Correction setting, make the change by moving up or

down the available selections one at a time.

• Use the following sequential order when making changes to the paper curl. This ensures

that the desired output is achieved:

Tip

Paper jams and wrinkled output may occur if the change is not performed in the recom-

mended sequential order; for example, using Default and then skipping to Type C.

Note

Always run test prints every time a setting is changed / selected; this allows you to

evaluate the output and determine if additional changes are necessary.

a. Default

b. Type A

c. Type B

d. Type C

e. Custom Curl Correction: Slight (Very Small) Upward or Slight (Very Small) Downward

f. Custom Curl Correction: Moderate (Small) Upward or Moderate (Small) Downward

g. Custom Curl Correction: Medium Upward or Medium Downward

h. Custom Curl Correction: Severe (Large) Upward or Severe (Large) Downward

Note

For more information, refer to Stock Library Manager Help for “Correcting Paper Curl,”

“Types A, B, and C.”

• If paper curl continues to persist after trying several or all of these settings, try decreasing

the image density on the print job or use a different type of paper.

• If paper curl is still a problem after decreasing the image density and after using a dif-

ferent type of paper, contact the Customer Support Center for further assistance.

Problem

Uneven Density / Mottle

Xerox Versant 3100 Press - Page 132