Xerox WorkCentre 7970 - Viewing, Saving, or Deleting a Certificate; Specifying the Minimum Certificate Key Length

Security
Xerox
®
WorkCentre
®
7970 Multifunction Printer 109
System Administrator Guide
6. Click Browse or Choose File, navigate to the signed certificate in .pem or PKCS#12 format, and click
Open or Choose.
7. Click Next.
8. Type a Friendly Name to help identify the certificate in the future.
9. Click Next.
The digital certificate appears in the list of Installed certificates.
Viewing, Saving, or Deleting a Certificate
1. On the Security Certificates page, click a certificate type tab.
2. To view or save a certificate, under Action, click View/Save.
Certificate details appear on the View/Save Device Certificate page.
a. To save the certificate file to your computer, at the bottom of the page, click Save Base-64
encoded (PEM).
b. Click Cancel to return to the Security Certificates page.
3. To delete a certificate, select the check box next to the certificate name and click Delete.
Note: You cannot delete the Default Xerox Device Certificate.
4. Click Reset to Machine/Device Factory Defaults to delete all certificates except the Default Xerox
®
Device Certificate.
Specifying the Minimum Certificate Key Length
You can specify the minimum encryption key length required for certificates. If a user attempts to
upload a certificate that contains a key that does not meet this requirement, a message appears. The
message alerts the user that the certificate they are attempting to upload does not meet the key length
requirement.
1. In CentreWare Internet Services, click Properties>Security.
2. Click Certificates>Certificate Key Length.
3. Under Minimum Encryption Key Length, select 1024-bit minimum, 2048-bit minimum, or No
Minimum.
4. Click Apply.