EasyManua.ls Logo

Xylem SonTek FlowTracker2 - 7.1.1 Equipment List; 7.1.2 Hardware Inspection

Xylem SonTek FlowTracker2
308 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SonTek a Xylem brand
FlowTracker2 User’s Manual (January 2019)
107
Measurement Process Section 7.
The Measurement Process involved for performing field measurements using a
FlowTracker2 instrument consists of number of components. It is important for both the
novice and experienced user that each of the components is followed to ensure that the
data collected during the measurement process is within acceptable standards and
quality. The main components that is the basis of the overall measurement process are
the following,
Office Procedures,
Measurement Site Information,
Pre Measurement Diagnostics,
Measurement Procedure,
Post Measurement Requirements.
Components within the Measurement Process should not be neglected due to lack of
operational experience, time or workload as this will compromise the data quality and
accuracy.
7.1. Office Procedures
The Office Procedures lists the steps that need to be performed to confirm the condition
and operation of the equipment and accessories before departure for field
measurements.
The verification of instruments and accessories before leaving the office is normally
neglected. It is highly recommended that instrumentation are inspected and tested
before each field measurement exercise.
Equipment List 7.1.1
Equipment List is an essential part in the planning and preparation stages of a field
measurement exercise. It is recommended that a comprehensive list is designed based
on user and or organizational requirements as this will ensure that all equipment is
prepared and packed before departing from the office. The equipment required for field
measurements are categorized under FlowTracker2 Instrument and user defined
measurement gear.
a) The FlowTracker2 Instrument and related accessories is detailed under
FlowTracker2 Case section. A reference sheet of the contents is supplied within
the FlowTracker2 carry case.
b) The user defined measurement gear is a list of items required in addition to the
FlowTracker2 Instrument to perform a field measurement.

Table of Contents