Xylem SonTek FlowTracker2 - 9.3.4.3 Discharge Summary

SonTek – a Xylem brand
FlowTracker2 User’s Manual (January 2019)
147
Add Gauge Height screen consists of the following
variables required in supplemental data,
a) Date,
b) Time,
c) Gauge Height,
d) Rated Discharge,
e) Temperature,
f) Salinity,
g) Comment.
c) To accept supplemental data,
i). Press the Right Soft Key,
d) To CANCEL supplemental data entry,
i). Press the Left Soft Key.
Figure 8:42 - Add Gauge Height
The staff gauge readings, rated discharge and associated data captured in
Supplemental Data should be accurate and complete. It is important that these
variables are entered correctly for accurate calculation of weighted gauge height and or
percentage discharge.
Discharge Summary 8.3.5.3
Discharge Summary from the data collection menu displays the discharge and other
variables measured from all completed stations. Discharge summary requires at least
one station with velocity measurements to populate the main variables in the table.
Discharge Summary screen consists of tabular
summary of discharge and other variables measured
up to specific point,
a) Discharge Summary, Table 8:12.
b) To close the discharge summary report,
i). Press the Left Soft Key.
ii). The software will navigate to the Data
Collection Window.
Figure 8:43 - Discharge
Summary
Properties associated with the variables and numerical calculations performed on the
raw data collected is defined in Table 8:12,
Table 8-12 - Discharge Summary
Variable
Description
Units
Decimal
Discharge
Total discharge is the sum of all station or
panel discharges, per discharge method.
m
3
/s or ft
3
/s
4
RatedQ
Rated discharge entered in supplemental data.
m
3
/s or ft
3
/s
4
Width
Total width calculated from all stations and or
m or ft
3