Xylem SonTek FlowTracker2 - 8.3.1.1 Add Station

SonTek – a Xylem brand
FlowTracker2 User’s Manual (January 2019)
123
Figure 8:6 - Data Collection Window
The operations and functions available of the Data Collection Window will be discussed
throughout this section with the main functions described in Figure 8:7.
Data Collection Window screen of the consists of
the following,
a) Station Management area defined in rectangle,
b) Add Station,
c) Data Collection Menu (Menu).
d) To add a station,
i). Press the Left Soft Key.
e) To select the data collection menu,
i). Press the Right Soft Key,
ii). The software will display a popup menu screen.
Figure 8:7 - Functions Data
Collection Window
Add Station 8.3.1.1
The Add Station function allows the user to add a station to the measurement section
based on the station types defined for Discharge Measurement technique. The
parameters required for creating a station is defined by the station type as discussed
under Station Types. There are several common parameters that are applicable to all
station types of which are listed below.
Add Station screen consist of the following common
parameters that are required for all station types,
a) Location,
b) Depth,
c) Station Type,
d) Correction Factor,
e) Comment.
The standard functions available for each station
type are,
f) Add Gauge Height,
g) Record GPS Location (function availability, see
GPS Station Tagging).
h) To add a station or start velocity measurement,
i). Press the Right Soft Key.
i) To CANCEL add station,
i). Press the Left Soft Key.
Figure 8:8 - Add Station
Delete Station 8.3.1.2
Deleting a station is performed from the Data Collection Window by selecting the
station within the viewable window.