SonTek – a Xylem brand
FlowTracker2 User’s Manual (January 2019)
160
Data Collection Window screen of the consists of
the following,
a) Station Management area defined in rectangle,
b) Add Station,
c) Data Collection Menu (Menu).
d) To add a station,
i). Press the Left Soft Key.
e) To select the data collection menu,
i). Press the Right Soft Key,
ii). The software will display a popup menu screen.
Figure 9:7 - Functions Data
Add Station 9.3.1.1
Add Station function creates a station for each measurement location identified for
velocity measurements. The process separates point velocity measurements with the
same position and or different measurement locations.
Add Station screen consist of the following
parameters that are required to create a station,
a) Location X,
b) Location Y,
c) Water Depth,
d) Measurement Depth,
e) Comment.
The standard functions available for each station
type are,
f) Record GPS Location (function availability, see
GPS Station Tagging).
g) To add a station or start velocity measurement,
i). Press the Right Soft Key.
h) To CANCEL add station,
i). Press the Left Soft Key.
Figure 9:8 - Add Station
Unique station number is assigned to each point velocity measurement. This allows the
user to perform multiple measurements at the same location without assigning a unique
number or name to differentiate between the measurements.
Properties associated with the parameters for station are defined in Table 9:3,
Table 9-3 - Station - Properties
To Next Page
Loading...