SonTek – a Xylem brand
FlowTracker2 User’s Manual (January 2019)
268
Fix quality
GPS fix quality if GPS fix was
recorded
HDOP if GPS fix was recorded
• Automatic beam check – For each station, the mean beam check data is
displayed below the station information summary table. The SNR for each ADV
beam is plotted with distance (“Range”) from the sample volume.
Samples 14.8.2.3
Figure 14:28. Layout of Samples
The Samples tab (Figure 14:28) contains the following plots. The point measurement
selection can be performed by selecting the appropriate station number in the “Station
Number” column on the left of plots. All point measurements at the same station will be
allocated the same station number. The header of each plot distinguishes between the
specific station number and point measurement.
• Velocities – X,Y, (and Z, if using a 3D probe) velocities measured during a station
point measurement spanning chosen sampling period,
• SNR – beam SNR measured during a station point measurement spanning
chosen sampling period,
• Temperature – Temperature measured during a station point measurement
spanning chosen sampling period,
To Next Page
Loading...