SonTek – a Xylem brand
FlowTracker2 User’s Manual (January 2019)
291
a) Sampling Volume is defined by the
Grey vertical line,
b) Averaging of beam profile data,
c) Beam Check file can be recorded
during manual Beam Check
Figure 15:4 – Manual Beam Check
Figure 15:5 – Automated Beam Check
a) Deployment instructions are supplied
before Automated Beam Check
commences,
b) The Lab-ADV collects approximately
12 seconds of beam profile data
during the Automated Beam Check,
c) Warnings will be supplied if any
criteria was exceeded during the
Automated Beam Check
Probe Info 15.3.4
Probe Info supplies the FlowTracker2 probe assembly information as recorded within the
firmware, as shown in Figure 15:6.
To Next Page
Loading...