Xylem SonTek FlowTracker2 - 14.3.3.2 Changing Software Display Decimals

SonTek – a Xylem brand
FlowTracker2 User’s Manual (January 2019)
243
Measurement
Unit Options
meters per second (m
3
/s), Liters per second (L/s),
Megaliters per day (ML/day), Million UK gallons per
day (Million UK gallons/day), Million US gallons per
day (Million US gallons/day), UK gallons per minute
(UK gallons/min), US gallons per minute (US
gallons/min)
Fraction Decimal
Decimal (), Percent (%)
Fraction Percent
Decimal (), Percent (%)
GPS Position
Degrees (DDD.dddd), Degrees minutes (DDD
MM.mmmm), Degrees minutes seconds (DDD MM
SS.ss)
Pressure
Bar (bar), Decibars (dbar), Feet of water (ft H
2
O),
Meters of water (m H
2
O), Pascal (Pa), Pound Force
per Square Inch (psi)
Salinity
Practical Salinity Scale (pss)
SNR
Decibels (dB)
Sound Speed
Centimeters per second (cm/s), Feet per second
(ft/s), Furlongs per fortnight (furlongs/fortnight),
Inches per second (in/s), Kilometers per hour
(km/h), Knots (kt), Meters per second (m/s), Miles
per hour (mph), Millimeters per second (mm/s),
Yards per second (yd/s)
Temperature
Celsius (
o
C), Fahrenheit (
o
F), Kelvin (
o
K)
Time Span
Seconds (s)
Voltage
Millivolts (mV), Volts (V)
Water Velocity
Centimeters per second (cm/s), Feet per second
(ft/s), Furlongs per fortnight (furlongs/fortnight),
Inches per second (in/s), Kilometers per hour
(km/h), Knots (kt), Meters per second (m/s), Miles
per hour (mph), Millimeters per second (mm/s),
Yards per second (yd/s)
To change units, click on the appropriate drop-down menu and select the unit desired.
There is an option on the lower right to change all relevant units to Metric or US/Imperial.
Click OK, and the software will automatically restart to apply the changes.
Changing Software Display Decimals (Settings > Units) 14.3.3.2
The number of decimals displayed by the software for various parameters can be
changed independently. Display decimals can be changed for all parameters listed in
Table 14:1. The display decimals range from 0 (0) to 9 (0.000000000). To change the
number of decimals displayed, click on the appropriate drop-down menu and select the
value desired. When display decimals are changed, the software will automatically
restart to apply those changes.