Xylem SonTek FlowTracker2 - 9.3.4 Data Collection Menu

SonTek – a Xylem brand
FlowTracker2 User’s Manual (January 2019)
172
Variable
Description
Units
Decimal
σV. Y
Standard error of Y velocity component.
m/s or ft/s
4
σV. Z
Standard error of Z velocity component.
m/s or ft/s
4
SNR. 1
Signal to noise ratio of Beam 1
dB
3
SNR. 2
Signal to noise ratio of Beam 2
dB
3
SNR. 3
Signal to noise ratio of Beam 3
dB
3
Angle
Flow angle relative to X direction
Degree
2
Bnd
Boundary QC value
n/a
n/a
Tilt
Mean wading rod angle during velocity
measurement
Degree 2
Temp
Mean temperature during measurement
°C or °F
2
Depth
Mean water depth from water surface during
point measurement
m or ft 3
Pressure
Mean water pressure during point
measurement
dbar 3
GPS -
Latitude
GPS derived Latitude DDD° MM' SS.SS
GPS -
Longitude
GPS derived Longitude DDD° MM' SS.SS
Data Collection Menu 9.3.4
Data Collection Menu allows the user to adjust measurement settings, view
measurement summary, perform automated beam check and complete the
measurement. The data collection menu can be accessed between station
measurements and this ensures that the instrument is configured for current flow
conditions present.
Data Collection Menu screen consists of the
following functions that are available in General
Mode,
a) Settings,
b) Summary,
c) Automated Beam Check,
d) PS Calibration,
e) Complete Measurement,
f) Discard Measurement,
g) Go to Home Screen.
h) To select a function,
i). Use the up or down arrow key to scroll through
the functions,
i) To open or CLOSE the data collection menu,
i). Press the Right Soft Key.
Figure 9:26 - Data Collection
Menu