SonTek – a Xylem brand
FlowTracker2 User’s Manual (January 2019)
262
Figure 14:24. Original FlowTracker .wad File Import Tool
The FlowTracker2 software supply two options to import Original FlowTracker data from
either the ASCII or WAD files, shown in Figure 14:24.
Figure 14:25. FlowTarcker1 Import
The criteria associated with each file format import are summarized in Table 14:2. Import
of ASCII files will preserve the Original FlowTracker discharge calculations. If any
editing is performed in FlowTracker2 software, the Original FlowTracker discharge will be
recalculated based on FlowTracker2 Engine.
Table 14-2. Original FlowTracker File Format Import
ASCII Not Recalculated
Original FlowTracker
Engine
The (4) ASCII and WAD files
must be present in the same
folder.
The .DIS, .DAT, .CTL, and
.SUM ASCII files are exported
using the Original FlowTracker
desktop software
WAD Recalculated
FlowTracker2 Engine
The WAD file must be present
in the folder.
ASCII: The “Put Headers on ASCII Files” option in the Original FlowTracker desktop
software must be selected before the ASCII files are created. This will ensure that
header information is placed at the top of the ASCII file.
To Next Page
Loading...