SonTek – a Xylem brand
FlowTracker2 User’s Manual (January 2019)
276
• Save Edited Data to File – after hitting the Apply Settings and Recompute
Discharge button, changes will appear in the values displayed in the software, but
these changes will not be saved to a file unless the Save Edited Data to File is
pressed. A file containing edits will be created in the same folder where the .ft file
resides with a “_edited” extension. Once this file is created, opening the .ft file will
open the edited file showing the last saved edits.
• Reload Last Saved Edits – after performing multiple edits that are not saved, this
button is used to revert back to the last saved edits.
• Revert to Original Data – reverts to the original .ft file that was downloaded from
the FlowTracker2 Handheld unit. The original .ft file will always be preserved
regardless of new edits saved.
• Lock File for Editing – enabling the feature will prevent any changes to the
original measurement file or edited data during post processing. If changes are
required to the measurement file or edited data set, the Lock File feature needs to
be disabled.
Original FlowTracker .wad File Editing 14.9.1.2
The editing of Original FlowTracker data (.wad files converted to
.OriginalFlowTracker1.ft) in FlowTracker2 Desktop Software is not enabled in this
software version. The Lock File feature will be enabled (Locked) when opening
.OriginalFlowTracker1.ft files, preventing any changes to the Original FlowTracker data.
To Next Page
Loading...