SonTek – a Xylem brand
FlowTracker2 User’s Manual (January 2019)
265
View Controls
Chart size + / Chart size -
Increase or decrease size of all
plots within software
Reset size of all plots to default
Main Viewing Pane 14.8.2
The main viewing pane consists of seven tabular views in Discharge Mode, and 6 tabs in
General Mode. The contents of each tab are described below.
Section 14.8.2.1
The Section plots (Figure 14:26) are shown with respect to station location. The left
bank is always shown at the left regardless of whether measurements were taken
starting at the left or right bank. Plots available are:
• Station discharge – discharge per station
• Velocity – mean velocity per sample. Blue vectors indicate the mean velocity
measured (in the X-direction with respect to the ADV probe). If multiple points
exist, the blue vector represents the vertical average. The red vector(s) indicate
actual velocity measured at each point, incorporating the Y-component of flow to
indicate the skew ness of the flow with respect to the X-axis.
• Depth – depth measured at each station (from user input at each station). The
actual measurement depths are indicated by dots. Hovering over the dots
produces a pop-up showing the actual depth those measurements were made.
To Next Page
Loading...