SonTek – a Xylem brand
FlowTracker2 User’s Manual (January 2019)
290
The Lab-ADV Configuration window, shown in Figure 15:3, consists of two sections. The
first requires the user to define the parameters specified in Table 15:1. The second
section consists of number of functions that enhance the measurement process.
Figure 15:3 - Lab-ADV Configuration
Load Configuration 15.3.1
Load Configuration allows the user to upload a configuration file based on previous
measurements configuration settings. This can simplify the setup process if the same
settings will be used for multiple measurements.
Save Configuration 15.3.2
Save Configuration allows the user to create a configuration file based on the current
configuration settings. The configuration file created will have the following file
extension.
*.labadv_config
Beam Check 15.3.3
The Beam Check function enables the user to perform either a Manual Beam Check or
Automated Beam Check.
To Next Page
Loading...