SonTek – a Xylem brand
FlowTracker2 User’s Manual (January 2019)
251
USB Connection (Device > USB) 14.5.1
To connect to the FlowTracker2 Handheld ADV using the USB to micro-USB
connection,
a) Plug the micro-USB connector to the communications connector at the bottom of
the Handheld unit (see Figure 1:1).
b) Plug the USB cable end into a USB port of your PC.
c) Ensure that you have the battery pack installed in the Handheld device with
sufficient battery power, and turn on your FlowTracker2.
d) From the main menu, navigate to the Communications button (Left panel of Figure
14:15) and click the Center Key. The FlowTracker2 will wait for a signal from the
PC, showing the screen in the right panel of Figure 14:15.
Figure 14:15. Communication dialog
e) From the FlowTracker2 Desktop Software, in the Device dialog, click the USB
button. The software will attempt to connect automatically with the FlowTracker2.
f) Once successfully connected, the FlowTracker2 data files will be listed, as shown
in Figure 14:16. The handheld will indicate that it is connected to your computer.
Bluetooth Connection 14.5.2
Do not use your Windows Bluetooth manager to pair the FlowTracker2 device to your
computer’s Bluetooth radio. The software will perform the pairing automatically.
To connect to the FlowTracker2 using Bluetooth,
a) Ensure that you have the battery pack installed in the Handheld device with
sufficient battery power, and turn on your FlowTracker2.
b) From the main menu, navigate to the Communications button (Left panel of Figure
14:14) and click the Center Key. The FlowTracker2 will wait for a signal from the
PC, showing the screen in the right panel of Figure 14:14.
To Next Page
Loading...