Xylem SonTek FlowTracker2 - Review Point Measurement

SonTek – a Xylem brand
FlowTracker2 User’s Manual (January 2019)
169
close to the sampling volume.
Step 4
Velocity Measurement screen displays graphical
display of raw data of the following variables during a
velocity measurement,
a) Velocity,
b) SNR,
c) Temperature,
d) Tilt,
e) Vel. Angle,
f) Probe Depth,
g) Battery,
h) Pressure.
Tilt and Velocity Angle indicators are situated on the
right hand side of the screen.
i) Tilt,
j) Velocity Angle,
k) Averaging Time left.
l) To select a variable graphical display,
i). Use up or down scroll arrows keys.
m) To stop sampling,
i). Press the Right Soft Key.
n) To CANCEL velocity measurement,
i). Press the Left Soft Key.
Figure 9:23 - Velocity
Measurement
The conventions and graphic display features used for displaying Velocity and SNR raw
data are defined under Raw Data Display.
Review Point Measurement 9.3.3.2
Review Point Measurement is a report supplied at the end of each point velocity
measurement. The report consists of two components, tabular summary of numerical
calculations performed on the raw data collected and graphical display of raw data.
Review Point Measurement screen consists of the
following tabular summary and graphical displays,
Tabular Display
a) Review Point Measurement, Table 9:6
Graphical Display of raw data are based on the
following variables,
b) Velocity,
c) SNR,
d) Temperature,
Figure 9:24 - Review Point