Yamaha Mio - Installing the Belt Drive

4 - 55
ENG
BELT DRIVE
7. Install:
• spring
• clutch carrier 1
NOTE:
_
• Attach the clutch spring holder 2 onto the
secondary sheave as shown. Then, com-
press the spring, and tighten the clutch car-
rier nut 3.
• Install the clutch carrier nut with the beveled
side of the nut facing the clutch carrier.
Clutch spring holder
90890-01337
2
1
3
3
1
EAS00325
INSTALLING THE BELT DRIVE
For installation, reverse the removal proce-
dure.
1. Install:
• gasket 1
• V-belt 2
• secondary sheave 3
CAUTION:
_
Do not allow grease to contact the V-belt,
secondary sheave assembly.
NOTE:
_
• The V-belt must be installed, with the arrows
a facing forward.
• Install the V-belt on the primary sheave, then
install the secondary sheave 3 along with
the V-belt 2.
• When installing the secondary sheave, do
not get grease from the inner surface of the
secondary sheave on the primary drive gear.
2
3
a
1
New
New