Yamaha Mio - Page 48

2 - 28
SPEC
CABLE ROUTING
Ì Fasten the wire harness with the holders.
Í Fasten the grommet on the wire harness with
the holder as shown.
Î Pass the front brake hose through the hose
guides.
Ï To the turn signal lights
Ð Pass the battery breather hose 2 through the
hole in the bottom cowling
.
Ñ Pass the battery breather hose 2 through the
hose guides on the footboard.
Ò Route the front turn signal light lead (left)
between the front turn signal light (left) and the
screw support on the front cowling as shown.
Ó Install the front turn signal light lead couplers in
the holders on the front cowling.
A
4
1
2
3
4
5
6
0
C
B
È
Ñ
Ò
Î
Ì
Ó
Ï
Î
Î
Í
Ì
Ð
Ë
Ê
É
È
A
A
B
C
A-A
B
C
D
4
7
8
9
D