7 - 41
– +
ELEC
SIGNALING SYSTEM
3.Flasher light and/or turn indicator light do not blink.
CONTINUITY
1.Bulb and bulb socket
●
Check the bulb and bulb socket for continu-
ity.
Refer to the “CHECKING OF BULBS” sec-
tion.
NO CONTINUITY
Bulb and/or bulb socket are faulty, replace.
CORRECT
2.Turn signal switch
●
Check the turn signal switch for continuity.
Refer to the “CHECKING THE
SWITCHES” section.
INCORRECT
Turn signal switch is faulty, replace handle-
bar switch (left).
MEETS SPECIFI-
CATION (12 V)
3.Voltage
●
Connect the pocket tester (DC 20 V) to the
flasher relay.
Tester (+) lead
→
Brown
1
terminal
Tester (–) lead
→
Frame ground
●
Turn the main switch to “ON”.
●
Check for voltage (12 V) on the “Brown”
lead at the flasher relay terminal.
*
OUT OF SPECIFICATION
Wiring circuit from main switch to flasher
relay connector is faulty, repair.
To Next Page
