7 - 40
– +
ELEC
SIGNALING SYSTEM
2.Brake light does not come on.
CONTINUITY
1.Bulb and bulb socket
●
Check the bulb and bulb socket for continu-
ity.
Refer to the “CHECKING OF BULBS” sec-
tion.
NO CONTINUITY
Bulb and/or bulb socket are faulty, replace.
CORRECT
2.Brake switch
●
Check the brake switches for continuity.
Refer to the “CHECKING THE
SWITCHES” section.
INCORRECT
Brake switch is faulty, replace it.
MEETS SPECIFI-
CATION (12 V)
3.Voltage
●
Connect the pocket tester (DC 20 V) to the
bulb socket connector.
Tester (+) lead
→
Yellow
1
terminal
Tester (–) lead
→
Black
2
terminal
●
Turn the main switch to “ON”.
●
The brake level is pulled in or brake pedal
is stopped down.
●
Check for voltage (12 V) on the “Yellow”
lead at the bulb socket connector.
This circuit is good.
OUT OF SPECIFICATION
Wiring circuit from main switch to bulb socket
connector is faulty, repair.
To Next Page
