11-17
11
11-5 Communication Command Description
COMMUNICATION WITH PC
(25)
@P <point number>
Sets the point variable P.
Point number : This can be any value from 0 to 999.
Transmission example : @P 100 c/r l/f ............................... Set the point variable P to 100.
Response example : OK c/r l/f
c
CAUTION
The contents of the point variable P are held even when the DRCX is turned off. However, when the program is
reset or when the program reset is applied for example by switching the execution program, the point variable P
will be initialized to 0.
(26)
@P+
Adds 1 to the point variable P.
Transmission example : @P+ c/r l/f ....................................
Increments the point variable P.
(P ← P+1)
Response example : OK c/r l/f
(27)
@P-
Subtracts 1 from the point variable P.
Transmission example : @P- c/r l/f .....................................
Decrements the point variable P.
(P ← P-1)
Response example : OK c/r l/f
(28)
@CSEL <array element number>
Specifies an array element for the counter array variable C to be used.
Array element number : This is a number used to designate an array element for the
counter array variable C, and can be from 0 to 31. The counter
variable D can also be specified here as the array element.
Transmission example : @CSEL 1 c/r l/f............................ Uses the counter array variable
C of element number 1 in the
subsequent steps.
Response example : OK c/r l/f
(29)
@C <counter value>
Sets a specified value in the counter array variable C specified with the CSEL statement.
Counter value : This can be any value from 0 to 65535.
Transmission example : @C 100 c/r l/f ............................... Sets the counter array variable
C to 100.
Response example : OK c/r l/f
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
