2 INFORM Explanation
FS100 2.2 Control Instruction : CALL
2-36
The following display appears. Then, make the setting of arguments.
Set “ARG. 1 to 8” on the left to “USE”, set “OUTPUT1 to 8” as
“COMMENT”, then select “BYTE” as “TYPE”. Select {EXECUTE} to
complete the registration of arguments.
4. Describe the job content.
(1) Describe lines to receive arguments.
Press [INFORM LIST], and select {CONTROL}, then “GETARG” to
register instructions to receive arguments. (To register the
GETARG instruction, select {Main Menu}, {SETUP}, then
{TEACHING COND.}, and set “LANGUAGE LEVEL” to
“EXPANDED”.) In this case, the above-mentioned COMMENT will
be automatically displayed as the comments on the line of
GETARG instructions as shown below. Note that arguments must
be received by the local variable.
To Next Page
Loading...
