3-2
Digital Operator
The Digital Operator is used for programming, operating, monitoring, and copying the Drive’s parame-
ters. To copy parameters, G7 Drives must have the same software version, model, and control method. The
various items included on the Digital Operator are described below.
-DRIVE- Rdy
Frequency Ref
U1-01= 60.00Hz
- - - - - - - - - - - - - - - - - - - - - - - - - - - - -
U1-02= 60.00Hz
U1-03= 10.05A
Drive Mode Indicators
See Table 3.2
Data Display
Displays monitor data, parameter data and settings
RUN & STOP Indicators
See Tables 3.5 and 3.6
Ready Display
Drive can operate when a Drive command is input
1 line x 13 characters
3 lines x 16 characters
Menu Display
Key Descriptions
See Table 3.1
-QUICK-
Contr ol Method
---------------------------------
A1-02= 3 *3*
Flux Vector
“2”
Currently Programmed Value
Present Selection (User adjusts)
Factory Default
Setting
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
