Drive Mode Indicators
3-9
Quick Programming Mode
In quick programming mode, the parameters required for Drive trial operation can be monitored and set.
Parameters can be changed from the setting displays. Use the Increment, Decrement, and Shift/RESET Keys
to change the frequency. The user parameter will be written and the monitor display will be returned to when
the DATA/ENTER Key is pressed after changing the setting.
Refer to Chapter 5 User Parameters for details on the parameters displayed in quick programming mode.
Example Operations
Key operations in quick programming mode are shown in the following figure.
Fig 3.3 Operations in Quick Programming Mode
** Main Menu **
-DRIVE-
Operation
** Main Menu **
-QUICK-
Quick Setting
** Main Menu **
-ADV-
Programming
** Main Menu **
-VERIFY-
Modified Consts
** Main Menu **
-A.TUNE-
Auto-Tuning
MENU
Control Method
-QUICK-
A1-02=2 *2*
Open Loop Vector
Reference Source
-QUICK-
b1-01=1 *1*
Terminals
MENU
MENU
MENU
MENU
ESC
DATA
ENTER
DATA
ENTER
ESC
Run Source
-QUICK-
b1-02=1 *1*
Terminals
Monitor Display
Frequency Setting Display
Mode Selection Display
MOL Fault Select
-QUICK-
L1-01=1 *1*
Std Fan Cooled
StallP Decel Sel
-QUICK-
L3-04=1 *1*
Enabled
Terminal AM Gain
-QUICK-
H4-05=0.50
A B
A B
Control Method
-QUICK-
A1-02= 2 *2*
Open Loop Vector
Reference Source
-QUICK-
b1-01= 1 *1*
Terminals
DATA
ENTER
ESC
Run Source
-QUICK-
b1-02= 1 *1*
Terminals
DATA
ENTER
ESC
Terminal AM Gain
-QUICK-
H4-05= 0 .50
MOL Fault Select
-QUICK-
L1-01= 1 *1*
Std Fan Cooled
StallP Decel Sel
-QUICK-
L3-04= 1 *1*
Enabled
DATA
ENTER
ESC
DATA
ENTER
ESC
DATA
ENTER
ESC
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
