YASKAWA GA800

642 YASKAWA TOEPYAIGA8002B GA800 Drive Programming
Terminal function selection ............................................ 633
Terminal A1 ................................................... 631, 633
Terminal A2 ................................................... 631, 633
Terminal A3 ................................................... 631, 634
Terminal AM .................................................. 631, 634
Terminal FM .................................................. 631, 634
Termination resistor
Setting switch ....................................................... 635
Test run
Checklist ............................................................. 607
Fine tuning .......................................................... 600
Procedure for no-load test run .................................... 598
Procedure for test run with actual load .......................... 598
Tightening torque
Control circuit terminals........................................... 627
Timer function
Parameter ............................................................ 220
Torque compensation
Parameter ............................................................ 288
Torque Compensation
Parameter ............................................................ 258
Torque Control
Parameter ............................................................ 287
Switching to/from Speed Control ................................ 290
Torque limit function
Parameter ............................................................ 472
Torque reference
Parameter ............................................................ 288
Trend Plot
Monitors ............................................................. 558
Tuning .................................................................... 247
U
U2, U3 Initialization .................................................... 525
Undertorque detection
Parameter ............................................................ 466
Unit of measurement setting
Acceleration and deceleration times ............................. 250
Unit selector ............................................................. 517
Up 2 command
Parameter ...................................................... 282, 287
Up command....................................................... 365–366
Parameter ...................................................... 282, 287
USB port ................................................................. 543
Connecting a PC .................................................... 636
User Monitor Select afterPowerUp ................................... 511
User Parameter Default Value ......................................... 518
User-Set Display Units Max Value ................................... 513
User-SetDisplayUnits Dec Display ................................... 513
Uv
Speed Search Selection at Start................................... 219
Uv1
Detection level settings ............................................ 449
V
V/f Pattern................................................................ 295
Second Motor ....................................................... 306
V/f Pattern Display Unit ............................................... 512
Verify
Parameters (keypad and drive) ................................... 568
W
Wire gauges
Control circuit terminals........................................... 627
Wiring
Control circuit terminal block .................................... 628
Control circuit terminals........................................... 623
Main circuit terminals.............................................. 621
Motor................................................................. 621
Z
Z pulse Auto-Tuning.................................................... 590
Zero Servo function
Parameter ............................................................ 245