3
Motion Module Setup
3.2.3
Module Configuration Definitions
3-30
( 2 ) Module Configuration Definition Settings
[ a ] Setting Items
The setting names and details for the Module configuration definition are shown in the following
table.
[ b ] Saving Module Configuration Definitions
1. Select File
−
Save from the menus.
2. Verify the displayed message and click the Yes Button to save the definition data.
[ c ] Deleting Module Configuration Definitions
1. Select File
−
Delete from the menus.
2. Verify the displayed message and click the Yes Button to delete the definition data.
[ d ] Ending the Module Configuration Definitions
Select File
−
Close from the menus to return to the Module Configuration Definition Window.
Setting Details
Slot Number
Displays the slot number.
Module Type
Sets the Module to be installed in each slot.
Circuit Number
Sets the circuit number for the Module.
I/O Start Register
Reserved
I/O End Register
Reserved
Motion Start Register
Sets the start address for the motion parameters register. This address is set
automatically according to the circuit number.
Motion End Register
Sets the end address for the motion parameters register. This address is set
automatically according to the circuit number.
Detail
−
Status
Displays each Module’s status when online.
WWW.NNC.IR
To Next Page
Loading...
