3.1
SVB-01 Module Setup
3-23
■
SERVOPACK Tab Page
Set the SERVOPACK parameters required for motion control on the SERVOPACK Tab Page.
• Refer to each SERVOPACK manual for information on the SERVOPACK parameters.
• When online, select Copy Current Value followed by Save so that the data saved in the SVB-01
Module and the data saved in the SERVOPACK will be the same.
• Some SERVOPACK parameter values are automatically assigned. Refer to 9.4 Parameters That Are
Automatically Updated for details.
Setting Details
Axis Number
Select the desired axis number. Set the SERVOPACK for each axis.
SERVOPACK
Displays the type of SERVOPACK.
Version
Displays the version of SERVOPACK.
Servo Type
(Motor Type)
Displays the motor type.
No.
Displays the parameter number of the SERVOPACK parameter.
Name
(Parameter Name)
Displays the parameter name.
Input Data (Set Data)
Input (or select) the parameter value (set value at the SVB-01 Module).
Unit
Displays the units of the corresponding parameter.
Current Value
Displays the current value of the SERVOPACK parameter that is saved
in the SERVOPACK when online.
INFO
WWW.NNC.IR
To Next Page
Loading...
