Fieldbus PCI-Card
To alter a setting for a specific node, type the desired node address and press [Enter].
View single node
This command displays information about a single node.
Fig. 35 Single node
To view or alter the settings for a specific node, type the desired node address and press [Enter].
Toggle node
This mode is used to alter the current operating mode of the module.
Fig. 36 Toggle mode
Press [ESC] to cancel.
Online/Offline mode
This command is used to toggle Online/Offline mode
Fig. 37 Online/Offline mode
Press [ESC] to cancel.
Page 46 Reg.No. ME00107EN-02
To Next Page
Loading...
